When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Manufacturer: Tripp Lite
Model: Tripp Lite SmartPro UPS LCD 1500VA 900W, Tower, 120V, New Batteries, Refurbished UPS
Condition: New batteries, refurbished UPS
Part Number: SMART1500LCDT
Maximum output: 900W / 1500VA
Typical backup time at half load: 10 minutes (450 Watts)
Typical backup time at full load: 4 minutes (900 Watts)
Warranty: 1 year full replacement warranty
Tripp Lite SmartPro LCD 1500VA 900W Tower 120V SMART1500LCDT Manual
SMART1500LCDT - Tripp Lite SmartPro LCD 1500VA Specifications:
Input:
Rated input current (Maximum Load)
12A
Nominal Input Voltage(s) Supported
120V AC
UPS Input Connection Type
NEMA 5-15P
Input Circuit Breakers
20A
UPS Input Cord Length (ft.)
6
UPS Input Cord Length (m)
1.8
Recommended Electrical Service
15A 120V
Input Phase
Single-Phase
Output:
Output Volt Amp Capacity (VA)
1500
Output kVA Capacity (kVA)
1.5
Output Watt Capacity (Watts)
900
Power Factor
0.8
Nominal Voltage Details
120v nominal output in battery mode
Frequency Compatibility
50 / 60 Hz
Frequency Compatibility Details
Automatic frequency selection
Output Voltage Regulation (Line Mode)
120V (+9% / -12%)
Output Voltage Regulation (Battery Mode)
120V (±10%)
UPS Output Receptacles (Surge Suppression Only)
5 UPS outlets, 5 surge-only outlets
Load Management Receptacles
Two switchable single-outlet 5-15R load banks
Output AC Waveform (AC Mode)
Sine wave
Output AC Waveform (Battery Mode)
PWM sine wave
Nominal Output Voltage(s) Supported
110V; 115V; 120V
Output Receptacles
(10) NEMA 5-15R
Individually Controllable Load Banks
No
Battery:
Half Load Runtime (min.)
10 minutes (450 watts)
DC System Voltage (VDC)
24
Battery Recharge Rate (Included Batteries)
Less than 8 hours from 10% to 90%
Internal UPS Replacement Battery Cartridge
RBC51 (requires 2)
Expandable Runtime
No
Voltage Regulation:
Voltage Regulation Description
Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 92 to 150
Overvoltage Correction
Input voltages between 129 and 147 are reduced by 15%
Undervoltage Correction
Input voltages between 92 and 108 are boosted by 18%
User Interface, Alerts & Controls:
Front Panel LCD Display
LCD screen with scroll buttons indicates Input voltage, Output voltage, Frequency (Hz), AVR boost / cut status,
Output load in watts, Output load percentage, Battery voltage and Estimated runtime in minutes
Switches
Power switch offers whole UPS power control; Scroll/mute button enables LCD selection options and silences audible alarm; Test button initiates self test
Alarm Cancel Operation
Power-fail alarm can be silenced using alarm-cancel switch
Audible Alarm
Audible alarm indicates power-failure and low-battery conditions
Surge / Noise Suppression:
UPS AC Suppression Joule Rating
650
UPS AC Suppression Response Time
Instantaneous
UPS Dataline Suppression
1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet; Coax jacks (1 set)
EMI / RFI AC Noise Suppression
Yes
Physical:
Cooling Method
Fan
Primary Form Factor
Tower
Primary UPS Depth (mm)
391
Primary UPS Height (mm)
203
Primary UPS Width (mm)
146
Shipping Dimensions (hwd / in.)
11.10 x 9.00 x 19.30
Shipping Weight (kg)
12.70
Shipping Weight (lbs.)
28.00
UPS Housing Material
Steel
UPS Power Module Dimensions (hwd, cm)
20.32 x 14.60 x 39.12
UPS Power Module Dimensions (hwd, in.)
8 x 5.75 x 15.4
UPS Power Module Weight (kg)
12.25
UPS Power Module Weight (lbs.)
27
Environmental:
Operating Temperature Range
+32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius
Storage Temperature Range
+5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius
Relative Humidity
0 to 95%, non-condensing
AC Mode BTU / Hr. (Full Load)
119
Battery Mode BTU / Hr. (Full Load)
867
AC Mode Efficiency Rating (100% Load)
95%
Communications:
Network Monitoring Port Description
Supports detailed monitoring of UPS and site power conditions
PowerAlert Software
For local monitoring via the UPS’s built-in USB port, download PowerAlert Local software at
[link removed by ]
Communications Cable
USB and cabling included
WatchDog Compatibility
Supports Watchdog application, OS and hard-reboot restart options for remote applications
Communications Interface
USB (HID enabled)